Catalogue 2021

www.incitefire.com.au for technical information 108 Shown with EL-24 24m exit sign fitted (sold separately). The recess adaptor bracket allow a semi-flush fitting of the EL-24 exit signs. The bracket needs to be fitted with an exit sign and a mounting base (not supplied) and are equipped with spring loaded clips for secure fixing to most suspended ceiling materials. The bracket features a small inspection hole in the ceiling plate which allows sight of the bicoloured status LED on the exit sign cup within the ceiling void. The NFW68/89-RA is a mounting adaptor for the Emergency Lighting product range and their associated mounting bases. It allows a base and light combination to be flush mounted by providing a recess fixing in the ceiling. (shown with luminaire fitted – not supplied) Allows all current Firescape luminaires to be flush mounted: EL-DL2-AS, EL-DL3-AS, NF89-O-AS, NF89-C-AS An LED-based, addressable step lighting unit, which is installed semi-flush. The stand-by battery is contained within the unit. Although low-level lighting is not a requirement under AS2293 this attractive and discreet unit is ideal for lighting stairway treads and changes in floor levels. EL-REC40 RECESS ADAPTOR EL-SL ADDRESSABLE STEP LUMINAIRE EL-PSU A bus-controlled Power Supply, which operates with the Firescape system providing charge to luminaire batteries. NOTE: A remote power supply is required to power any non-addressable slave luminaires. Switched-mode power source Parallel connection for outputs max. 2.5 mm 2 Outputs: 12 V dc / 24 V dc (2 x 5 A) Batteries: 2 units, 7 Ah / 1 hr standby time Group-specific monitoring of emergency lighting Controlled using EL-IO units Designed for 12/24 lights EL-GRAPH An alarm graphics package which allows the end-user to visually check on the status of the complete Firescape system, down to individual point status. Fully integrated graphics package Individual point monitoring Reports point status information Point interrogation and control EL-IMP A configuration and programming software tool for use with the EL-2 emergency lighting control panel. The software is used to configure light levels, set up lighting areas and create input and output parameters during set-up and commissioning. Allows configuration of luminaires Allows configuration of input/output devices Assists in fault finding Allows uploading and downloading of data Assists in report generation and retrieval NFW68/89-RA RECESS ADAPTOR ACCESSORIES