TCH-B200 Instructions

NSW 02 9644 7144 QLD 07 3252 5366 VIC 03 9544 2211 WA 08 9349 2972 2-3-0-237/ISS5/SEP15 programming socket on the TCH-B200 and then connect the black croc clip to the C terminal, and the red croc clip to the L terminal on the base sounder. The address can now be programmed as described above.  To program a CHQ-SIM, CHQ-POM, CHQ-WS or any HCP Manual Call Point a PL-3 Programming Lead must be used, firstly connect the plug into the remote programming socket on the TCH-B200 and then connect the square plug into the programming socket on the device. The address can now be programmed as described above. Please note that when programming CHQ-BS, CHQ-WS, CHQ-WS2 or the CHQ-WSB the maximum address permissible is 254. Individual device and Control Panel instructions should be checked for address range. Operation - Analogue Level Reading If the device is an AIC-E / AIE-E then the analogue reading should be ignored for the first 30 seconds until the device stabilises. To read the analogue level of a sensor:  Locate the sensor on the programmer and switch on as described in the previous section.  Press the centre (blue ) key, an ‘A’ (for analogue value) will be displaye d followed by the analogue value of the Sensor which will be constantly updated for up to 3 minutes or until the right (grey) key is pressed to switch the unit off. Remote Programming Socket and Programming Leads The remote programming socket allows the user to program other ESP devices that contain the EEPROM technology utilising a Programming Lead. Programming Socket PL-2 Programming Lead Caution  Only to be used with the ESP Programmer and Hochiki loop devices.  Do not short croc clips together.  Remove from programmer when not in use. PL-3 Programming Lead Ancillary Functions In addition to the main functions the TCH-B200 may display the following messages: bAt If displayed on subsequent power on, a low battery voltage should be suspected - this facility will operate with sufficient life in the battery for approximately 3000 address setting operations left. E0 Attempting to program an address greater than 127 E1 Attempting to program an address with no Sensor connected E2 Cannot find Sensor on power on E3 Non valid response from ASX sensor E4 Cannot find a device to program E5 Device read error E6 Fail during analogue level reading your