TCH-B200 Instructions

NSW 02 9644 7144 QLD 07 3252 5366 VIC 03 9544 2211 WA 08 9349 2972 2-3-0-237/ISS5/SEP15 HOCHIKI TCH-B200 – ESP DEVICE PROGRAMMER OPERATING INSTRUCTIONS General Description The TCH-B200 ESP Programmer is designed for use with the following products: ALK / ALG-ALN C Analogue Photoelectric Sensors AIE-E C Analogue Ionisation Sensor ATG-E C Analogue Heat Sensor CHQ-WS2 C Wall Sounder ATJ / ACB-E C / ACB-EW 2 Analogue Multi-Heat Sensors CHQ-WSB/WSB2 C Wall Sounder Beacons ACC / ACA-E C Analogue Multi-Sensors YBO-BS C Base Sounder YBO-BSB/BSB2 C Base Sounder Beacons HCP Range 3 Analogue Manual Call Points CHQ-CB/WB/AB C Addressable Beacons CHQ-POM 3 Powered Output Module CHQ-SIM 3 Single Input Module CHQ-ARI C Addressable Remote Indicator C = device clips straight onto Programmer, 2 = in conjunction with PL-2 Programming Lead, 3 = in conjunction with PL-3 Programming Lead The programmer is used to set the address of the above products for use with Hochiki ESP systems. The unit is designed to be light, robust and easy to use and operates from a single PP3 size, heavy-duty battery which gives the capacity for up to 8,000 operations. Keys The TCH-B200 has 3 operating keys, a middle blue key and lower left and right grey keys, these keys have the following functions.  Left (grey key) key - Power On - automatically reads the address of the fitted sensor - subsequent operations of this key will advance the programmer address in units of 10.  Right (grey key) key - Advances the programmer address display in units of 1. Also used as the Power Off button.  Centre (Blue key) key - Stores the displayed address to the Sensor and is used to read the Sensor’s analogue levels. Operation - Address Setting  Locate the Device onto the programmer ensuring the 3 locating pips line up with the grooves in the programmer.  Press the left (grey) key to switch the programmer on, a battery check message will be displayed followed by the address of the device fitted (previously un-programmed devices will read 127).  Select the required address by incrementing the programmer display (left grey k ey, 10’s, right grey key, units). Whilst the display is showing an address different to that stored in the device, 3 dots will also flash.  Once the wanted address is displayed press the centre (blue) key to store the address in the device. Once the address is correctly stored the 3 dots will cease to flash and the display will show the address set.  To program a CHQ-BS a PL-2 Programming Lead must be used, firstly connect the plug into the remote (Blue)